Bracket for fixing Heat Sinks on xESC Motor Controller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Should prevent the heat sinks from shaking loose from xESC board over time and potentially causing a short circuit.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I use the xESCs in an OpenMower robotic lawn mower. This bracket is intended to prevent the heat sinks from shaking loose from the xESC board over time and potentially causing a short circuit. I use them for two month now (during summer) and they work very well so far.
The bracket is clipped with the hooks to the pcb of the xESC Mini. Mine are the ones Gadgets By Vermut included in the OpenMower kit v0.11 with STM32 mpu.
- xESC Homepage: https://github.com/ClemensElflein/xESC
- Gadgets By Vermut: https://shop.devops.care/
- OpenMower: https://openmower.de/
The dimensions of the heat sinks are (the bracket will only hold with these dimensions):
- 9x9x12mm for the STM32
- 20x14x11mm
I use PC, but PETG or ABS are probably suitable as well, PLA will not be heat resistant enough to use it in a mower outside in the sun.