1 / 1
Bike - Cateye rear light saddle rail mount - angled rails
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount a Cateye light on the angled saddle rails
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 131
- Wydruki
- 0
- Wyświetlenia
- 633
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
I really liked my solution for Ergon Saddles, and copied the design over to the saddle rail interface from this solution BUT a design that wouldn't interfere with my saddle position being pushed totally forward like this one would. So, this design sits on the angled portion of the saddle rails.
Only tested on a WTB Volt saddle. Most saddle angles will differ.
IMPORTANT NOTE: PETG will creep, I suggest installing the mount, waiting an hour and checking again.
Requires Hardware:
- 2x M4x16mm bolt
- 2x M4 hex nut
Print Settings:
- Material: PETG
- Perimeters: ≥4
- Layer Height: ≥.2
- Support: YES, tree supports required. See uploaded gcode for reference.
- Brim: Yes, see uploaded gcode for reference