1 / 1
Peg for IKEA IVAR system (OpenSCAD, parametric) — zdjęcie 1

Peg for IKEA IVAR system (OpenSCAD, parametric)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For custom modules, in case no original pegs (metal) are at hand.

Ocena
5 / 5
Polubienia
42
Pobrania
198
Wydruki
1
Wyświetlenia
788
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Recommend to print in PETG. With high Infill value or even better with 10+ perimeters, and layer height of >0.2mm.

In case you need to adjust the design, the OpenSCAD file is made available (though it is a very basic model to say the least :P).

 

Disclaimer
I did not run any tests or simulations. With that said please take precaution with regards to loads on the pegs. Its not metal. Its plastic. Even PETG will break at some point. So I don't take any responsibility for your own prints, if anything goes wrong - it's on you only. ;-)

In addition I am not affiliated, associated, authorized, endorsed by, or in any way officially connected to any brands and/or trademarks named.

Tagi