Milwaukee Fuel TS100 / Pinecil Power Adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adaptor based on macsboost's Milwaukee connector - use your TS100 or Pinecil soldering iron on an M18 Fuel battery.
- Ocena
- 5 / 5
- Polubienia
- 51
- Pobrania
- 165
- Wydruki
- 0
- Wyświetlenia
- 2565
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
An adaptor based on macsboost's Milwaukee connector, to allow you to use your TS100 soldering iron on an M18 Fuel battery.
Print instructions
Category: Electronics Summary
An adaptor based on macsboost's Milwaukee connector, to allow you to use your TS100 soldering iron on an M18 Fuel battery.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
</div>Supports:No
Resolution:
.2
</div>Infill:20%
Filament: Sunlu PETG Black
Notes:
Print the main adaptor body with the largest face down. Print the small wiring cover with the side the that the wire exits down.
Clean holes up my running appropriate sized drills through them. I printed without supports, so needed to do a bit of clean up on the overhanging rails that the battery slides onto / engages with.
Spade terminals are epoxied into the channels in the main body so they don't get pushed back into the adaptor when you slide it onto the battery.
Wiring cover is secured with two M3 x 6 self tapping cap head screws.
The cable is wired so that the plug that is inserted into the iron is centre positive. Plug is 5.5 x 2.5mm.