Ubiquiti u6+ / u6-lite / nanoHD octagon box compatible mount

Known good for: U6+, U6-lite, nanoHD
 → The U6-Pro has a different mounting bracket, this model does not work with the U6-Pro.
 → Unknown if this works with the U6-LR or not.

This is a remix of a replacement of the original wall/flat surface bracket here on Printables – modified to have mounting holes for octagon boxes (ceiling boxes in North America - unsure if this is the same format used in other areas) 

The main variant included has standoffs since the screw holes in the box are recessed, this provides a backing to prevent bending the plate/overtightening it to the box. A second version without standoffs is also included, which keeps the original screw holes so that it's also usable as a direct to surface mount, just like the original, however that version can be overtightened/bent into an octagon box if it's screw holes are recessed (see photos - orange example has a gap)

The two screw holes for the octagon box are flat-bottomed to be compatible with the screws that come with most octagon boxes, keeping the heads of the screws recessed into the plate and out of the way of the AP. These holes leave 0.2mm of “Break-through” material that might need to be poked out if the screw isnt sharp.

Space for the wire to come out of the box and into the AP remains when mounted.
 

Material: Any (I've used PLA, PETG and ASA)

Layer height: 0.2mm & 0.3mm tested
  → if using thicker layers, preview your layers, ensure the “break-through” layer will print 1 layer over the two flat-bottomed holes, otherwise later layers will try to print over air if supports are disabled

Infill: recommend 15-20%, if below 15%, it might be a good idea to use more than 2 perimeters

Supports: Not Required (2 holes will use “Break-through” material that might need to be poked out if the screw isnt sharp.)