1 / 3
FT EMS V0.2 Rear Panel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified rear cover that compliments EMS V0.2 V1/V2
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 72
- Wydruki
- 2
- Wyświetlenia
- 728
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 3)Remiksy (0)Kolekcje (46)Powiązane
INTRODUCTION
This modified rear cover for the Voron V0 was designed to address 2 issues: -
- Allow more air in and out of the rear chamber
- Complement EMS V0.2 from a design aspect
THE DESIGN
The design is a direct replacement for the rear cover so no additional screws are required. You will need the bigger fan which we currently support the 8010 and 92mm standard PC fans.
INSTALLATION
- Attach the fan of your choice from the inside using the screws that work with the fan you are using.
- Remove the small fan that originally came with the V0 and plug the big fan in its place. You may need to cut the connector and install a JST.
- DONE!
If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :)
Should you have any questions you can reach out to us via Discord