DeWalt trim router dust shroud (DWP611, DCW600, A27941)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Capture dust from edge routing using DeWalt trim routers
- Ocena
- 4,5 / 5
- Polubienia
- 78
- Pobrania
- 499
- Wydruki
- 2
- Wyświetlenia
- 2481
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I really don't like dust flying around my garage, routing edges was always one of the worst offenders. This shroud, combined with the standard dust collection port for DeWalt trim routers, will nearly eliminate stray dust from edge routing (flush trimming, roundovers, chamfers, etc.)
It snaps on or off the 4 holes on the router base plate (A27941), no hardware required! The dust will be caught by the shroud, and will then be extracted by the above-base dust collection.
I'm using this on a DCW600, I'm pretty sure it's the same plate as used on the DWP611 corded trim router.
I printed this in PETG, upside down, with supports for the rim of the shroud.
