1 / 2
BTT ADXL345 mount with Creality CR6 bed mount holes — zdjęcie 1
1 / 2

BTT ADXL345 mount with Creality CR6 bed mount holes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A holder for the BTT ADXL345 sensor, intended for input shaping usage.

Ocena
0 / 5
Polubienia
12
Pobrania
101
Wydruki
0
Wyświetlenia
1126
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

A holder for the BTT ADXL345 sensor, intended for input shaping usage.

This is intended to be printed and kept stuck on the bed (keep the bed warm) and tested. The two 3mm holes should allow easy self-tapping by any normal M3 screw - the piece is 5mm thick, so make sure any screws do not go too deep and into the hotbed surface (test as required).

It also has two 3.5mm holes spaced 14mm apart that should allow mounting at the glass bed holder mounts at the front and rear of the hotbed (on the Creality CR6).

The BTT ADXL345 mounting holes itself are two M3 holes spaced 44m apart (center-center), in case you wish to create your own.

Tagi