BTT ADXL345 mount with Creality CR6 bed mount holes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holder for the BTT ADXL345 sensor, intended for input shaping usage.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 101
- Makes
- 0
- Views
- 1,126
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
A holder for the BTT ADXL345 sensor, intended for input shaping usage.
This is intended to be printed and kept stuck on the bed (keep the bed warm) and tested. The two 3mm holes should allow easy self-tapping by any normal M3 screw - the piece is 5mm thick, so make sure any screws do not go too deep and into the hotbed surface (test as required).
It also has two 3.5mm holes spaced 14mm apart that should allow mounting at the glass bed holder mounts at the front and rear of the hotbed (on the Creality CR6).
The BTT ADXL345 mounting holes itself are two M3 holes spaced 44m apart (center-center), in case you wish to create your own.