Chain guide adapter for YT Jeffsy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to mount a "Funn Zippa Lite MTB Chain Guide" to a first gen YT Jeffsy.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 773
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Adapter to mount a "Funn Zippa Lite MTB Chain Guide" to a first gen YT Jeffsy. The chain guard is the E-type/S3 type.
The rear bolt goes straight through to the frame, so the 3D printed adapter is not entirely relied on for strength. It's extremely strong and stiff. This is not a true E-type adapter, it sits quite a bit lower. I'm using a 30T chainring, and I have the chain guide near the 36T position. I doubt a 32T chainring would fit with this design.
You need an M5x25 socket head cap screw, and an M5x12 socket head cap screw.
Link to the chain guide: https://www.amazon.com/dp/B01N7ETE4D/ref=cm_sw_r_tw_dp_x_SPBtFbGSKPY7H
Print Settings
Resolution:
0.2
Infill:
100%
Filament:
MakeShaper ABS
Notes:
I printed it solid with ABS. But it probably works with anything above 30% infill. PETG would also work.
Category: Sport & Outdoors