Greenhouse bottom door slider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My greenhouse door was knocked out last year by a storm.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 1016
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My greenhouse door was knocked out last year by a storm.
The replacement plastic part was too expensive for 4 grams of plastic, so I remade one from scratch that is better than original. Some parts are reinforced in comparison to the original.
Works perfect since one year. Easy to print. Have two doors (left, right), just mirror it.
Works on my Vitavia / Pergart Uranus, so will work on similar ones, too like Mars, Diana and so on. Could work on several others, too.
Up to now the second original part broke, so I replaced it, too. Also works up to now.
Just use original screws.
Print instructions
Any layer height will work.
Print in PETG or ASA for longer use outdoor.
Because of the original measurements use a 0.4mm nozzle.
Used 100% infill for strong part so print slow.