Instrument level sensor wall mount (type 2"/58mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Robust 58 mm wall-mount bracket for instrument level sensors, designed as a practical replacement mounting solution.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A practical replacement wall-mount bracket designed for an instrument / tank level sensor with an approximately 58 mm mounting interface.
The bracket provides a rigid mounting surface while positioning and protecting the sensor body away from the wall. It is intended for replacement, retrofit or custom installations where the original mounting hardware is damaged, missing or unsuitable.
The sensor is supported using a standard white 32mm plumbing pipe as the shaft, making the mount cheap and easy to adapt to different installation heights. Cut the pipe to the required length and fit it between the printed bracket and sensor assembly.
Printing recommendations
Material: PETG recommended
Layer height: 0.20 mm
Walls: 4+
Infill: 30–50%
Supports: Depending on print orientation
Nozzle: 0.4 mm or larger
For outdoor, utility-room or industrial use, I would choose PETG, ASA or ABS rather than PLA.
Compatibility
Designed around a 58 mm instrument/sensor mounting geometry. Check the dimensions of your sensor before printing, as similar level sensors may use slightly different housings.
Printables “designer note”
If you successfully use this mount with a specific sensor model, please leave a Make or comment with the model number so compatibility can be documented.