1 / 3
Anycubic i3 Mega housing for 12864 LCD Graphic Smart Display Controller Board
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a housing which can be used to mount a "12864 LCD Graphic Smart Display Controller Board" to an Anycubic i3…
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 142
- Wydruki
- 1
- Wyświetlenia
- 1143
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (19)Powiązane
This is a housing which can be used to mount a "12864 LCD Graphic Smart Display Controller Board" to an Anycubic i3 Mega.
BOM:
- 4x M3 5mm screw, 4x M3 washer (to mount the holders)
- 4x M3 10mm screw (to mount the screen)
- 2x M4 12mm screw, 2x M4 washer, 2x M4 nut (to mount the housing to the holders)
I won't provide an adjusted firmware to make this display operational with an Anycubic i3 Mega/S!
Print instructions
Print Settings
- Infill: 20%
- Support: no
- Perimeters: 6
- Extrusion width: 0.45
- Layer height: 0.2, 1mm top/bottom thickness
- Filament: PETG, ASA, ABS
Post-Printing
Rework the 4mm holes of the holders
To make the holes printable without using any supports, I closed them with a 0.2mm thin layer. Just use a screwdriver/knife or a 4mm drill to open them entirely again.