1 / 6
IQaudio DAC Pro Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for Raspberry Pi 3 with IQaudio DAC Pro hat, with use of GPIO pins and screw tabs for permanent mounting.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 316
- Wydruki
- 0
- Wyświetlenia
- 2059
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (20)Powiązane
This is remix of Stamos fantastic Hifiberry Case.
The original model was modified as follows
- dimensions were adjusted to IQaudio DAC Pro High-Fidelity-Audio-Output-HAT
- the case was extended in height to allow using the GPIO pins
- a hole for a M12 cable gland was added to feed a data cable into the case towards the GPIO pins, e.g. for connecting I2C modules like an OLED or for switching a relay.
- screw tabs were added to allow wall mounting
The case was designed and tested with a Raspberry Pi 3 Model B.
For the full assembly you need:
- the printed parts
- Raspberry Pi with SD Card and power adapter
- IQaudio DAC Pro
- 4x Nylon spacers (10 mm, M2.5)
- 4x Nylon nuts
- 4x M2.5 with 6 mm length metal screws
- M12 cable gland
The model on the pictures was printed with PLA (Prusament Galaxy Black) with 0.2 mm layer height and 4 perimeters.