1 / 3
Kingroon KLP1 Belt Tensioner — zdjęcie 1
1 / 3

Kingroon KLP1 Belt Tensioner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A belt tensioner for the Kingroon KLP1 that does not require you to disassemble the hotend.

Ocena
5 / 5
Polubienia
34
Pobrania
232
Wydruki
1
Wyświetlenia
1935
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

On the KLP1 you have to always disassemble the hotend to reach the screws that keep the belt in place in case you want to change belts or tighten it more. This is really annoying and honestly just a bad design.

So i made a belt tensioner that doesn't require disassembly of the hotend. It basicly works like the original one and you can reuse the same screws, but now you screw down the belt lock diagonally from the rear. 

Print at 100% infill and with “normal” support “everywhere”. Use a small layer height like 0.1 to give it more strength.

Tagi