Clerty - Engraved Sign (Instead of Embossed/Raised Text)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Text is engraved instead of raised, allowing for filling with Lacquer Paintstik (or other text fill methods)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Printed fine for me but may be errors in the model - just quickly made in PrusaSlicer using new negative volume tools, then exported to STL and ‘auto-repaired’ in Windows 3D Builder.
I've got more experience dealing with filling in of engraved text than coloring of raised text, so I opted to go with what I know. Plus I wanted the ‘DIRTY’ side's font to have more of a ‘dirty’ feel to it compared to the ‘CLEAN’ side's font.
- I personally use a lacquer-based paintstick to fill in the text with decent results. With the raised edge/lip around the text surface plane it is a bit more tricky to do, and my result wasn't as good as previous implementations of this method because of this (but was still very acceptable)
- Pretty simple: rub paintstick in to text to fill, wipe away excess with mineral oil soaked towels/q-tips.
- Here are examples of the product I use (no affiliate links)
There are lots of other methods to fill in text, such as thin oil based paint in a syringe, z-hop infill printing, etc etc.
My Print Settings:
Orientation: Print ‘face down’ (with gears side on build plate)
Layer Height: 0.2mm
First Layer Height: 0.28mm
Nozzle Diameter: 0.6mm (0.4mm also works)
Perimeters: 3
Ironing: ENABLED (PrusaSlicer default sub-settings worked for me, incl. ‘All Top Surfaces’)
Top Solid Infill Pattern / Solid Infill Pattern: Monotonic Lines (not anchored)
Infill: 25%
Infill Pattern: Adaptive Cubic
Supports: Yes (I did just the end of the floating edge where the gear will sit, see image)
Modifiers:
- Height Range Modifier
- Range 6.70mm - 7.08mm
- Layers and Perimeters
- Perimeters: 1
- Leave others as is
- Layers and Perimeters
- Range 6.70mm - 7.08mm
Using this Height Range Modifier (when using the same First Layer& Layer Heights as me) will only use 1 perimeter on the top 2 layers of text.
I like to use 1 perimeter around the surface layer edge of text for a cleaner look. (I don't have much experience ironing - this may be redudant when ironing)