Kingroon KLP1 Shrouded Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
KLP1 fan duct upgrade for better cooling distribution. No support needed. Recommend to print at 0.15mm layer hight.
- Ocena
- 4,25 / 5
- Polubienia
- 42
- Pobrania
- 553
- Wydruki
- 4
- Wyświetlenia
- 2813
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Basically a wider original duct with a vent attach to the back.
It can just replace OEM part without modifying housing.
Recommend to print at 0.15mm layer hight.
Use only one screw to bolt on original spot.
No Support Needed
This desigh can be printed with out support.
Just chose the chamfered side down like this.
PLA@220C 50-80 degrees overhang test result
No issue untill 80 degrees start showing some sagging.
Orca v1.63 slowdown for overhang speed 0/20/20/5
PETG@240C comparison
OME duct on the right my desigh on the left.
Not the best color for comparison but thats all I got for PETG :(
Still you can see better result on 80 degrees useable result on 70
