1 / 2
Customizable remote holder (Fusion360)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Very simple remote holder, but it work fantastically and I no longer lost my remote I though I'd share it.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
Easily customizable remote holder. You only need to change 6 parameter to fit your remote:
- height: the length of your remote, minus maybe 10-20mm to leave part of the remote to pull out
- length: the width of your remote
- width_open_end: how thick your remote is
- width_closed_end: normally you don't need to change this. It's set to create a 6mm slope so your remote can fall in easier and stay there
- wall_thickness: if your nozzle is 0.4mm then 2 layer = 0.8mm would be perfect. If your nozzle is 0.6 or above then set it to that as only 1 layer is sufficient
- bottom_curve: most remote have curved bottom. this is where you can set how curved it is
Print it in its original orientation: open end up top. Will take around 1 hour, but obviously differ based on how big your remote is.
Afterward, use a double sided tape to secure it. I've used them for over a year and can testify that normal double sided tape have enough strength to hold all our remotes.