1 / 2
Customizable remote holder (Fusion360)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Very simple remote holder, but it work fantastically and I no longer lost my remote I though I'd share it.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 22
- Makes
- 0
- Views
- 166
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
Easily customizable remote holder. You only need to change 6 parameter to fit your remote:
- height: the length of your remote, minus maybe 10-20mm to leave part of the remote to pull out
- length: the width of your remote
- width_open_end: how thick your remote is
- width_closed_end: normally you don't need to change this. It's set to create a 6mm slope so your remote can fall in easier and stay there
- wall_thickness: if your nozzle is 0.4mm then 2 layer = 0.8mm would be perfect. If your nozzle is 0.6 or above then set it to that as only 1 layer is sufficient
- bottom_curve: most remote have curved bottom. this is where you can set how curved it is
Print it in its original orientation: open end up top. Will take around 1 hour, but obviously differ based on how big your remote is.
Afterward, use a double sided tape to secure it. I've used them for over a year and can testify that normal double sided tape have enough strength to hold all our remotes.