1 / 3
VORON 0.2 Lower Rear Panel with MCU fan on right side — zdjęcie 1
1 / 3

VORON 0.2 Lower Rear Panel with MCU fan on right side

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the lower rear panel with 80mm fan mount, but mounted on the opposite side from the filament spool

Ocena
5 / 5
Polubienia
27
Pobrania
158
Wydruki
2
Wyświetlenia
1187
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Remix of the lower rear panel with 80mm fan mount, but mounted on the opposite side from the filament spool.

You can mount either 8010 or 8015 fans since it won't get in the way of the spool. For my build I used a 8015 Delta electronics fan (AFB0812HB). It has enough static pressure to push through the electronics to the exhaust holes.

Like the original there are two versions :

  • Full piece to be printed, you can use M3x4 heat set inserts

  • Laser cut 3mm acrylic and use M3 nuts for mounting - use the dxf file

 

If anyone is wondering about the temps, they are much better than with the stock 3010 fan. during an ABS print, I get 40°C on the mcu AND on the RPi with the fan at around 40-50% speed.

I'll join the fan config I use (I found it on reddit a while ago but can't find the link to credit the author).

 

You can get the fan cover from the original Printables.

Check out my other Voron 0 mods

Tagi