1 / 3
Prius V5 Yeti 22 oz. Rambler Cup Adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yeti Rambler cup holder for a PriusV5
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 691
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Prius V5 Yeti 18 oz. Rambler Cup Holder Adapter
Problem: YETI Rambler 18 oz bottle is too large to fit in a Prius V5 front cup holder.
Solution: make an adapter.
Notes:
- Original cupholder is tapered (67.5mm at the bottom x 75mm at the top & is 84.5 mm deep. The Yeti Rambler is 78mm wide, with straight sides.
- The lower half of the adapter is tapered to fit the cup holder. The top half is not tapered & is tall enough (84mm) to keep the Yeti Rambler from tipping out.
- The fit around the Yeti Rambler is a perfect fit, so as not to rattle in the car. Because the fit is almost perfect you get a little vacuum effect when removing the Yeti. This was solved with a vent hole in the bottom of the adapter.
- If you would like the adapter to fit very snuggly in the cup holder use any small spacer (eg. small piece of paper towel, a piece of very thin foam or a small piece of an Amazon bubble envelope).
- PLA will work if not in hot climate areas otherwise suggest using a tempered PLA or PET/PETG to avoid softening when the interior of car gets very hot.