Cymbal Stand Headphone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Headphone holder which clamps to 19mm (3/4") outside diameter cymbal/drum stands.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 388
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
Summary
This is a headphone holder which clamps to cymbal or drum stands. I designed this so I could hang my headphones off my Hi-Hat stand so they are always in the right spot when I sit down to practice. This model was designed to fit my PDP 2 leg Hi-Hat stand, your results may vary but this should fit on a wide variety of drum hardware.
I included the fusion 360 and step files if you want to try modifying the files, but be warned, I was very new to 3D modeling when I designed this, so it may be difficult to adjust the diameter of tube this can mount to.
Some Assembly Required
In order to make the clamp part actually clamp, you will need to add the brass inserts as well as have some M4 screws handy. It is probably possible to use regular nuts/washers with the M4 screws, but I have not tried this. If you do not have 10mm long M4 screws, longer screws would work but they may stick out the back. I use a soldering iron set to the printing temperature of the plastic I am working with to insert the brass inserts.
Parts List:
- 2x Brass Inserts - M4 x 8mm length x 6mm outer diameter
- 2x M4 screws - 10mm (or longer)