Nutribullet Blade Holder for Ikea Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Nutribullet Extractor Cross Blade and Milling Blade holder for IKEA SKÅDIS pegboards
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 341
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is a holder for Nutribullet Extractor Cross Blades and Milling Blades for IKEA SKÅDIS pegboards. It uses the Skadis T-Nuts Mounting System for a secure, rattle-free hold.
 | Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. |
Looking for a regular wall mounted version instead? Check out the screw-mounted version.
Blade Compatibility
This works with the Nutribullet Extractor Cross Blade and the Milling Blade. Chances are that it also work with the Pro Extractor Cross Blade. Please verify the dimensions of your blade. It works with blades that have a diameter of about 105mm and are about 42mm tall.
Required Hardware
| Qty | Description | Sourcing |
|---|---|---|
| 2 | M2.5x12mm Socket Head Cap Screw ** | Aliexpress |
| 2 | M2.5 DIN934 Hex Nut | Aliexpress |
** Screw lengths up to 20mm are fine
Printed Parts
| Qty | Part | Download |
|---|---|---|
| 1 | Skadis Nutribullet Holder.stl | this project |
| 2 | Skadis Nutribullet Holder Plug.stl | this project |
| 2 | Skadis T-Nut M2.5.stl | Download here |
Printing
Print the parts in the original orientation. All STLs are pre-rotated for printing.
Recommended settings for 0.4mm nozzle:
- Layer height: 0.2mm
- Extrusion width: 0.4 - 0.45mm
- Perimeters: 4
- Infill: 20%
- Top / bottom solid layers: 4
- Supports: No
Assembly & Installation
Step 1: Prepare T-Nuts
Insert the hex nuts into the bottom of the T-Nuts. The nuts should fit tightly and not fall out. Use superglue if the fit is loose and be careful to not get any glue onto the threads.
Step 2: Insert Plugs
Insert the alignment plugs into the holder. You may optionally use superglue to permanently stick the plugs to the holder.
Step 3: Insert Screws
Push the M2.5 screws all the way into the screw holes of the plugs.
Step 4: Install T-Nuts
Screw the T-Nuts onto the back of the holder until there is a gap of about 2mm between the T-Nuts and the holder.
Step 5: Installation
Align the T-Nuts in the vertical orientation and push the whole assembly into the desired holes on the pegboard.
While maintaining some pressure on the screw driver, tighten the screws. The T-Nuts will orient themselves in the horizontal position.
 |  |
Removal
To remove, loosen the screws about half a turn and pull the whole assembly off the pegboard.