JeSc Tevo Tarantula Layer Fan with 18mm sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016 And the 30-40…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016
And the 30-40 version I also used http://www.thingiverse.com/thing:1759396 by Galane, published Sep 8, 2016
I added an 18mm inductive sensor holder as an upgrade
Print both in ABS, because it is very close to the hot end and PLA will melt!
OFFSET SENSOR:
Y offset = 0
X offset = 40
Z offset = up to you ;)
Adjust Marlin firmware configuration.h (approx. line 604-605)
define X_PROBE_OFFSET_FROM_EXTRUDER 40 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
The 30-30 version needs as additional parts:
1x Cooling fans 30x30x10mm
4x Bolds m3x50
The 30-40 version needs as additional parts:
1x Cooling fan 40x40x10 or 40x40x20
4x Bolds m3x50 to attach fan duct
4x Bolds m3x20 or m3x30 to attach 40x40mm fan
Print instructions
Category: 3D Printing Summary
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016
And the 30-40 version I also used http://www.thingiverse.com/thing:1759396 by Galane, published Sep 8, 2016
I added an 18mm inductive sensor holder as an upgrade
Print both in ABS, because it is very close to the hot end and PLA will melt!
OFFSET SENSOR:
Y offset = 0
X offset = 40
Z offset = up to you ;)
Adjust Marlin firmware configuration.h (approx. line 604-605)
define X_PROBE_OFFSET_FROM_EXTRUDER 40 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
The 30-30 version needs as additional parts:
1x Cooling fans 30x30x10mm
4x Bolds m3x50
The 30-40 version needs as additional parts:
1x Cooling fan 40x40x10 or 40x40x20
4x Bolds m3x50 to attach fan duct
4x Bolds m3x20 or m3x30 to attach 40x40mm fan
Print Settings
Printer:
Tevo Tarantula
Rafts:
Doesn't Matter
</div>Supports:Doesn't Matter
Resolution:
N/A
</div>Infill:at least 25% 3D Honey cone