JeSc Tevo Tarantula Layer Fan with 18mm sensor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016 And the 30-40…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 14
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016
And the 30-40 version I also used http://www.thingiverse.com/thing:1759396 by Galane, published Sep 8, 2016
I added an 18mm inductive sensor holder as an upgrade
Print both in ABS, because it is very close to the hot end and PLA will melt!
OFFSET SENSOR:
Y offset = 0
X offset = 40
Z offset = up to you ;)
Adjust Marlin firmware configuration.h (approx. line 604-605)
define X_PROBE_OFFSET_FROM_EXTRUDER 40 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
The 30-30 version needs as additional parts:
1x Cooling fans 30x30x10mm
4x Bolds m3x50
The 30-40 version needs as additional parts:
1x Cooling fan 40x40x10 or 40x40x20
4x Bolds m3x50 to attach fan duct
4x Bolds m3x20 or m3x30 to attach 40x40mm fan
Print instructions
Category: 3D Printing Summary
Made both fan ducts using http://www.thingiverse.com/thing:1591912 by sobezuki, published May 27, 2016
And the 30-40 version I also used http://www.thingiverse.com/thing:1759396 by Galane, published Sep 8, 2016
I added an 18mm inductive sensor holder as an upgrade
Print both in ABS, because it is very close to the hot end and PLA will melt!
OFFSET SENSOR:
Y offset = 0
X offset = 40
Z offset = up to you ;)
Adjust Marlin firmware configuration.h (approx. line 604-605)
define X_PROBE_OFFSET_FROM_EXTRUDER 40 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
The 30-30 version needs as additional parts:
1x Cooling fans 30x30x10mm
4x Bolds m3x50
The 30-40 version needs as additional parts:
1x Cooling fan 40x40x10 or 40x40x20
4x Bolds m3x50 to attach fan duct
4x Bolds m3x20 or m3x30 to attach 40x40mm fan
Print Settings
Printer:
Tevo Tarantula
Rafts:
Doesn't Matter
</div>Supports:Doesn't Matter
Resolution:
N/A
</div>Infill:at least 25% 3D Honey cone