Ender 3 Pro Z-Axis Motor Mount Extender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds 1mm to the mount spacing to make the lead screw true-vertical.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 109
- Wydruki
- 3
- Wyświetlenia
- 780
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
My lead screw nut center is 22mm away from the printer arm. The motor mount is 21mm (42/2). I designed this mount to make the stepper shaft line up true vertical. The other requirement was to use the same screws that the original mount used. There are 2 holes for additional 3mm screws if desired. I have only tried this on the Ender 3 pro; other printers may have the holes in the correct place.
To check your lead screw - move the gantry to the top (as seen in photo) and measure gap. Then measure the gap closer to the stepper motor. I had a diff of 1mm. This mount will move the motor out 1mm.