Ender 3 Pro Z-Axis Motor Mount Extender
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adds 1mm to the mount spacing to make the lead screw true-vertical.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 109
- Makes
- 3
- Views
- 781
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
My lead screw nut center is 22mm away from the printer arm. The motor mount is 21mm (42/2). I designed this mount to make the stepper shaft line up true vertical. The other requirement was to use the same screws that the original mount used. There are 2 holes for additional 3mm screws if desired. I have only tried this on the Ender 3 pro; other printers may have the holes in the correct place.
To check your lead screw - move the gantry to the top (as seen in photo) and measure gap. Then measure the gap closer to the stepper motor. I had a diff of 1mm. This mount will move the motor out 1mm.