Xiegu G-106 Protection Rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I took IU1OPK's design for the FT891, shrunk some things, cut a few things, did some stuff, and now there is a rail…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I took IU1OPK's design for the FT891, shrunk some things, cut a few things, did some stuff, and now there is a rail for the Xiegu G106. The holes on this are a tad off, to fix this, i slightly drilled the hole a little wider. In the future, I can add the hole correctly.
Additionally, future work includes two feet on the bottom so this radio can be angled for viewing pleasure.
I used PETG (Stringy) at 80 percent and printed flat. PLEASE if you are printing anything to protect your radio or use outdoors, DONT USE PLA. Friends don't let friends use PLA.
No extra screws needed. The screws that are in the xiegu now, will fit the xiegu later.
-Ham Mediocre-er.
www.youtube.com/c/hamradiodude
Category: Electronics