Black and Decker Junior Carpenter Tool Box Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The latch on my daughter's play toolbox was missing when we bought it second-hand so I modeled a replacement.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 263
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The latch on my daughter's play toolbox was missing when we bought it second-hand so I modeled a replacement. This design prints in two pieces. The larger of the two needs supports under the small cylinders which clip into the smaller piece. I printed them at a 1.2mm layer height at 15% infill, 3 top and bottom layers and 3 walls. Not sure how much that last part matters but the parts printed with no issues at those settings. Make sure your settings are dialed in pretty well because the snap-fit of the two parts is pretty tight.