Black and Decker Junior Carpenter Tool Box Latch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The latch on my daughter's play toolbox was missing when we bought it second-hand so I modeled a replacement.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 263
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The latch on my daughter's play toolbox was missing when we bought it second-hand so I modeled a replacement. This design prints in two pieces. The larger of the two needs supports under the small cylinders which clip into the smaller piece. I printed them at a 1.2mm layer height at 15% infill, 3 top and bottom layers and 3 walls. Not sure how much that last part matters but the parts printed with no issues at those settings. Make sure your settings are dialed in pretty well because the snap-fit of the two parts is pretty tight.