Filament Drybox Monitor and Drying Controller for Pi Pico W
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A project for monitoring the inside of a drybox and controlling a heater, with local OLED and remote MQTT monitoring.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 841
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Disclaimer: This was a personal project, and I'm happy with how it turned out but was also a good project to test and learn things. If your only goal is to monitor a drybox or make a dryer with a minimum of effort, this is not a project for you. Maybe this gives you some ideas, but I wouldn't claim this is the most effective use of time or resources…
Description:
Uses a Raspberry Pi Pico W to control a heater and monitor the environment inside of a drybox. Includes schematic diagram, lots of photos and code. Displays all information locally on an OLED display, and remotely via MQTT. Example MQTT dashboards are provided. Uses:
- One (1) externally-mounted enclosure and
- One (1) internally-mounted sensor and circulation fan enclosure.
Code and Theory of Operation:
Refer to the GitHub page for code and a more detailed operation. The control box is mounted outside the drybox and an internal sensor and circulation fan are connected via an RJ45 bulkhead and a simple CAT5/etc patch cord. A 120VAC heater of any wattage can be connected to the internal plug, and all connections are pluggable.
Bill of Materials:
- Raspberry Pi Pico W
- DKS-SOLDERBREAD#02 Protoboard
- SSD1306 OLED on breakout board, configured for SPI
- RJ45 Bulkhead adapter
- 120VAC cord, cord ends, and strain relief connector
- 5-12V panel-mount LEDs
- Rotary encoder
- 120VAC heater, any type.
- Fuseholder
- 40, 80, or 120mm case fan
- Various 0.100" “Dupont” style connectors and pins
- Relay shield with 10A contacts, minimum
- DPST switch
- Fused IEC Power Entry Module
- 120VAC : 12VDC (1A) PSU
- 5-15R outlet
- 0.1 uf and 10 uf capacitor
- 7805 - 5V linear regulator
- Adafruit 4832 HTU31 breakout
- 2 x PN2222A BJT transistors
- 1/4W Resistors: 0.33k, 1k, 3.3k, 10k
- M3, M4 brass heat inserts
- M3, M4 countersunk screws
Print & Assembly Instructions:
- I printed in PETG for heat resistance, and enabled supports for the inside “windows” on my external enclosure so that the lines stayed nice and straight, no issues with bridging.
- HTU31 mounts and relay shield inserts are M2.
- PSU, Protoboard, CAT5 clamps, cover, inserts are M3.
- SSD1306 mounting holes are M3 countersunk.
- Enclosure hanging screws are M4 countersunk.
- The relay shield I used fits precisely into the notches, other relay shield types will require different mounts - use the Fusion 360 archive files to modify.
Example Dashboards:

Fig. 1 – Heating mode.

Fig. 2 – Switching to monitoring mode, with silica gel.