Replacement rotor for AniOne "Jolly Butterfly" cat toy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement rotor for the AniOne "Jolly Butterfly" cat toy. It allows to use a piece of filament as the wire.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created this replacement rotor for the AniOne “Jolly Butterfly” because the cat did not like the butterfly. It was more stimulated by a piece of string dragged over the ground.
To install this rotor just remove the originally one and press it on the motor shaft. The rotor has several holes in which you can but a piece of filament with a piece of string or anything else at the end.
Just be careful not to put to much weight on the rotor system. The motor in the toy is really weak.
Caution
I advice you not to leave the cat unattended during use. It might start chewing on the rotor or the filament.
Print instructions:
- recommended layer height 0,2 mm
- No supports needed
I would be happy to see some of your makes posted :)
Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.