1 / 4
Replacement rotor for AniOne "Jolly Butterfly" cat toy — image 1
1 / 4

Replacement rotor for AniOne "Jolly Butterfly" cat toy

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a replacement rotor for the AniOne "Jolly Butterfly" cat toy. It allows to use a piece of filament as the wire.

Rating
0 / 5
Likes
3
Downloads
5
Makes
0
Views
114
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial — Share Alike

I created this replacement rotor for the AniOne “Jolly Butterfly” because the cat did not like the butterfly. It was more stimulated by a piece of string dragged over the ground.

To install this rotor just remove the originally one and press it on the motor shaft. The rotor has several holes in which you can but a piece of filament with a piece of string or anything else at the end.

Just be careful not to put to much weight on the rotor system. The motor in the toy is really weak.

Caution

I advice you not to leave the cat unattended during use. It might start chewing on the rotor or the filament.

Print instructions:
  • recommended layer height 0,2 mm
  • No supports needed

 

I would be happy to see some of your makes posted :)

Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.

Tags