RGB status bar diffuser for MK4/S, MK3.9/S, mk3.5/S & XL
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extension for more visible signal LED panel on the bottom edge of Original Prusa MK4 and XL xLCD printers.
- Ocena
- 4,923 / 5
- Polubienia
- 128
- Pobrania
- 405
- Wydruki
- 33
- Wyświetlenia
- 2333
- Oceny
- 26
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Update:
- Adding a NEW V3 VERSION with a full length that runs along the entire bottom edge of the xLCD cover and guides the light perfectly along its entire length.
- Adding a NEW V2 VERSION that is shape improved and the diffusion part is reduced to a perfect design line.
Printing suggestions:
Material: any crystal clear PETG filament
Layer: .20 mm is sufficient
Infill: 100% to improve light transmission
Flow: recommended 105% to ensure full fill
——
Check out my new xLCD cover for XL, MK4, MK3.9 and MK3.5.
——
Installation:
Slide the part onto the bottom edge of the xLCD cover (same for MK4 and XL). No screws are required, and it is likely that no glue is necessary. There is no need to disassemble the xLCD for installation. It can be easily slipped onto the xLCD that has already been assembled and mounted on the printer, be VERY CAREFUL not to damage the LEDs on the xLCD printed circuit board during the slipping process!
