Volt / Ammeter Enclosure for pixels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Created this basic enclosure that utilizes PG7 glands to provide a little nicer looking volt/ammeter for my x-connect.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Created this basic enclosure that utilizes PG7 glands to provide a little nicer looking volt/ammeter for my x-connect. It has enough room to store a 3x6 wago or a 2x4, along with a normal ago to allow you to wire everything together. Definitely not optimized for space savings but simple to print
The screw holes were designed for m2.5 screws to thread into the PLA. Suggest going with at least 3 perimeters.
The meter I used were from this amazon listing
https://www.amazon.com/dp/B0B7J29FFZ
which shows the specifications for the meter as "about 1.88 x 0.8 x 1.1 inches"
This is not designed to be weather proof.