1 / 4
long reach soundhole clamp / bridge clamp (for guitar repair) — zdjęcie 1
1 / 4

long reach soundhole clamp / bridge clamp (for guitar repair)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A clamp I needed to glue my guitar's bridge.

Ocena
5 / 5
Polubienia
52
Pobrania
306
Wydruki
2
Wyświetlenia
1354
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

My guitar's bridge broke off, so I wanted to glue it back on, but I needed some suitable clamp to hold it in place while the glue sets. LoboCNC had designed one, but it was a bit too short for my guitar and a bit too big for my Prusa Mini,  and so I designed my own, it worked great.

Printing: For the bar use lots of top and bottom layers (say 8), and even more walls/perimeters (say, 12). For the two arms use lots of walls/perimeters and even more top/bottom layers. I used PLA, which is more rigid than PETG. 

Split the model into objects to assign different layer and perimeter settings to each part or to mark them as printable/not printable or to reorient them. On the Prusa Mini I printed the arms one at a time and diagonally.

I also used a 0.4mm nozzle and 0.2mm layer height, but bigger values there should be fine, too.

Tagi