long reach soundhole clamp / bridge clamp (for guitar repair)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A clamp I needed to glue my guitar's bridge.
- Rating
- 5 / 5
- Likes
- 52
- Downloads
- 307
- Makes
- 2
- Views
- 1,359
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
My guitar's bridge broke off, so I wanted to glue it back on, but I needed some suitable clamp to hold it in place while the glue sets. LoboCNC had designed one, but it was a bit too short for my guitar and a bit too big for my Prusa Mini, and so I designed my own, it worked great.
Printing: For the bar use lots of top and bottom layers (say 8), and even more walls/perimeters (say, 12). For the two arms use lots of walls/perimeters and even more top/bottom layers. I used PLA, which is more rigid than PETG.
Split the model into objects to assign different layer and perimeter settings to each part or to mark them as printable/not printable or to reorient them. On the Prusa Mini I printed the arms one at a time and diagonally.
I also used a 0.4mm nozzle and 0.2mm layer height, but bigger values there should be fine, too.