1 / 6
Sovol Dual Spool Filament Dryer - Temperature Accuracy Upgrade Guide — zdjęcie 1
1 / 6

Sovol Dual Spool Filament Dryer - Temperature Accuracy Upgrade Guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improve drying performance and reduce chamber humidity with this simple modification.

Ocena
0 / 5
Polubienia
56
Pobrania
71
Wydruki
1
Wyświetlenia
2665
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

NOTE: I've changed the instructions to allow for use up to 50c.

-----------------------------------------------------------------------------------------------------------

I’ve generally been pretty happy with this dryer, however, the placement of the thermistor on the heater element means that the chamber temp set points were never reached. As a result, the best chamber humidity I ever reached was ~25% rH. 

So I finally got around to modding it - this is very simple and requires zero extra components. All you need is a soldering iron and a couple of pieces of heat shrink tube.

Now I’m getting accurate chamber temps and rH down to 18%.

1/ Remove the 4 Philips head Screws

2/ Use a plastic tool to scrape off the black tape (do NOT use metal, you’ll damage the PCB heater). Then de-solder both the thermistor.

3/ Solder ~30mm of wire to each of the thermistor legs and then apply shrink tube and solder the thermistor back down. Let the thermistor sit slightly above the PCB.

5/ Enjoy your higher performing Filament dryer!

 

Update: I’ve since been able to get even better results by drilling intake holes at the rear, just behind the fan, and drilling some  in the top of the lid. See pics. This lets the drier hold the humidity at a constant 14%.

Tagi