Headlamp right-angle lamp headstrap quickrelease mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My mount consists of a mounting plate and a half pipe holder. The lamp can then be strapped with an elastic bungee cord.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 503
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
A lot of currently available headlamps share the same type of mounting on the headstraps. The mount consists of a couple rubbery rings that have to slip over the body of the lamp. This is ok for a one time task, but if you want to use the lamp also as a standard torch this mount is awful.
My mount consists of a mounting plate and a half pipe holder screwed together with M3 screws. The lamp can then be strapped with an elastic bungee cord to the holder.
Plate: With cuts for sliding the strap into place without cutting and sewing.
Holder:
Two symetrical parts mounted next to each other. No need for brim or support.
A recess within each half pipe for holding a rubber strip (to avoid the lamp to rotate). The recess has pockets at the ends to insert the rubber strip. My use rubber strip is a industrial foam rubber 30mm long, 5mm width and 2.8mm thick. I glued the rubber in place.
The elastic bungee cord I used was a camping utility with 2mm thickness. The hole is 4mm so other cords will do.