Surge Protector Mount - Countersunk Screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Surge protector mount, with a 1.5" wide x 1.25" tall opening. Will fit between outlets spaced 0.5" or more apart.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Surge protector mount, with a 1.5" wide x 1.25" tall opening.
Will fit between outlets spaced 0.5" or more apart.
There is a countersunk hole on each end, that should accept up to #8 (5/32") screws…though, the head may sit a little proud, with larger sized countersunk screws.
V1 has all 90 degree angles.
V2 has angle relief by the screw holes, on the base.
Print on side, for best results. No supports needed. Any material you want.
My settings…
PLA
Layer lines: 0.2mm
Line width: 0.4mm
Wall count: 3 ea
Top/Bottom layers: 4 ea (for extra structural support)
Infill: 10-25% (it needs to retain a little flexibility for if surge protector is SLIGHTLY larger)
Infill pattern: anything
Build plate adhesion: brim (to relieve cooling strain on sharp first layer angles)
I hope this helps you. If it does, please give it a comment and a like!
All constructive criticism and suggestions are welcome!