1 / 5

Gridfinity - Engineer Pliers Bins

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Assortment of Gridfinity bins to store and organize between 1 and 4 Engineer pliers.

Aktualizacja u źródła: 2 lis 2023

Informacje o modelu

Assortment of Gridfinity bins to store and organize Engineer pliers.

The bins are all 3 units high. Their width varies depending on the number of pliers stored.

I tested the bins with the pliers shown below:

Other pliers like the one supplied with the Prusa MK3S/+ kit are also fitting.

Compatible pliers
NP-05	Micro nippers
NS-04	Micro nippers
NS-06	Micro nippers
NZ-03	Chip cutter
PS-01	Miniature long nose pliers
PS-03	Miniature needle nose pliers
PS-04	Miniature flat nose pliers
PZ-57	Screw removal pliers (Nejisaurus)

Print Settings
Material	I printed and tested with PETG for impact resistance. Other materials like PLA should be just fine too but I haven't tested the model with it.
Supports	I recommend using paint-on supports at each of the unit intersections (the blue “dots”) and using organic supports (I don't know how I could live without organic supports).
Nozzle and Layer Height	Nozzle: I printed and tested with a 0.4n, a 0.6n should work just fine and will print a bit faster too. Layer Height: I recommend 0.3mm layer height. 0.2mm layer height worked fine too during testing but it takes significantly longer (12+ hours), and I had some minor adhesion issues in two of the corners after 10 hours. 0.3mm printed much faster (~8 hours) and looked just as fine if not better.
Top fill pattern	Hilbert curves everywhere! I am a sucker for Hilbert curves, I like the finish it gives on top surfaces instead of the linear finish. This is totally optional…