1 / 5

Gridfinity - Engineer Pliers Bins

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Assortment of Gridfinity bins to store and organize between 1 and 4 Engineer pliers.

Updated at source: Nov 2, 2023

Model information

Assortment of Gridfinity bins to store and organize Engineer pliers.

The bins are all 3 units high. Their width varies depending on the number of pliers stored.

I tested the bins with the pliers shown below:

Other pliers like the one supplied with the Prusa MK3S/+ kit are also fitting.

Compatible pliers
NP-05	Micro nippers
NS-04	Micro nippers
NS-06	Micro nippers
NZ-03	Chip cutter
PS-01	Miniature long nose pliers
PS-03	Miniature needle nose pliers
PS-04	Miniature flat nose pliers
PZ-57	Screw removal pliers (Nejisaurus)

Print Settings
Material	I printed and tested with PETG for impact resistance. Other materials like PLA should be just fine too but I haven't tested the model with it.
Supports	I recommend using paint-on supports at each of the unit intersections (the blue “dots”) and using organic supports (I don't know how I could live without organic supports).
Nozzle and Layer Height	Nozzle: I printed and tested with a 0.4n, a 0.6n should work just fine and will print a bit faster too. Layer Height: I recommend 0.3mm layer height. 0.2mm layer height worked fine too during testing but it takes significantly longer (12+ hours), and I had some minor adhesion issues in two of the corners after 10 hours. 0.3mm printed much faster (~8 hours) and looked just as fine if not better.
Top fill pattern	Hilbert curves everywhere! I am a sucker for Hilbert curves, I like the finish it gives on top surfaces instead of the linear finish. This is totally optional…