3.5 inch drive bay blank Virgo ATX Tower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement bay cover for the Virgo ATX tower case
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Printing:
Material: PLA/PETG
Layers: 0.2mm
Supports: Normal
Support base pattern spacing: 4mm, makes them easier to remove and uses less material.
Use a blocker on the central part, the roof doesn't need supports due to the ribs.
Wall loops: 3
Outer wall speed: Slow, if you want a nice smooth finish
Infill direction: 45 (to make it less visible)
Why:
These are replicas of the Virgo ATX tower case 3.5 inch drive bay covers because the ones in my restoration project are more than 15 years old and even after retrobriting, are still severely discoloured, probably due to the fact the previous owner was a heavy smoker.
I modelled in Fusion using an oringal bay cover as the source, measured and recreated almost mm for mm.
I took some liberties including strengthing the rib that is used to secure the retaining clips and increasing the clip length by 1 mm so that they grab the chassis better.
Other than that, they are almost 100% dimensionally accurate and sit perfectly flush in my tower.
The supports break away very easily and left a nice clean base/roof, you may need a crafting knife to clean up the support material between the retaining clips if it doen't come away with the main block.