Gargoyle Pipe Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to snugly fit over an 18mm outside diameter pipe, a decorative way to keep wasps from nesting inside the pipe.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 149
- Wydruki
- 1
- Wyświetlenia
- 1176
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
This is a remix of Misterdid's gargoyle on Thingiverse (https://www.thingiverse.com/thing:2471156), designed to snugly fit over an 18mm outside diameter pipe. It has a small hole in the bottom of the tube for a grub screw to further secure it to the pipe. Intended as a decorative way to keep wasps from nesting inside the pipe. :-)
Print Settings
Printer Brand: SeeMeCNC
Printer: Rostock MAX v2
Rafts: No
Supports: Yes
Resolution: 0.3 mm layer height, 0.6mm width
Infill: 10%
Notes:
I did a fair amount of sculpting in Meshmixer to minimize overhangs when printed horizontally. Support is still needed up to the mouth, however.
Category: Decor