BTT Smart Filament Sensor Direct Mount For Sprite Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Seems like no one had made a Direct Sprite mount for that sensor, so I decided to make one. I had an issue with the…
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 122
- Wydruki
- 1
- Wyświetlenia
- 1009
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Seems like no one had made a Direct Sprite mount for that sensor, so I decided to make one.
I had an issue with the sensor when it was mounted way too far away from the extruder, so there was a lot of slag. About 20 cm of filament between the extruder and the sensor, so it was constantly pausing, assuming it's jammed. I had to crank up the run out distance so high that it wasn't'smart'' sensor anymore.
With this mount u can keep the recommended 7 mm Run out distance and the sensor works like intended (personally I use 10 mm)
No additional hardware needed, you use the 4 screws that came with the Sprite, and just screw the mount on the side of the extruder with the original extruder screws. Everything should fit together like a glove.
I decided to add the whole extruder model and the basic casing too, in case someone wants to remix parts, for example, add a V Knob back of the basic case and insert in somewhere in the V profiles.
Every model I upload comes with the Step files, I believe it helps the community.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Yes
Resolution:
0.20
Infill:
100%
Filament: Polymaker PLA Charcoal Black
Notes:
I used 100% infill just to make sure it's not so wobbly. 20% most likely works fine too.
Post-Printing =============
Use those 4 screws to install it.
Category: 3D Printing