BTT Smart Filament Sensor Direct Mount For Sprite Pro
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Seems like no one had made a Direct Sprite mount for that sensor, so I decided to make one. I had an issue with the…
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 122
- Makes
- 1
- Views
- 1,009
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Seems like no one had made a Direct Sprite mount for that sensor, so I decided to make one.
I had an issue with the sensor when it was mounted way too far away from the extruder, so there was a lot of slag. About 20 cm of filament between the extruder and the sensor, so it was constantly pausing, assuming it's jammed. I had to crank up the run out distance so high that it wasn't'smart'' sensor anymore.
With this mount u can keep the recommended 7 mm Run out distance and the sensor works like intended (personally I use 10 mm)
No additional hardware needed, you use the 4 screws that came with the Sprite, and just screw the mount on the side of the extruder with the original extruder screws. Everything should fit together like a glove.
I decided to add the whole extruder model and the basic casing too, in case someone wants to remix parts, for example, add a V Knob back of the basic case and insert in somewhere in the V profiles.
Every model I upload comes with the Step files, I believe it helps the community.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Yes
Resolution:
0.20
Infill:
100%
Filament: Polymaker PLA Charcoal Black
Notes:
I used 100% infill just to make sure it's not so wobbly. 20% most likely works fine too.
Post-Printing =============
Use those 4 screws to install it.
Category: 3D Printing