Footholder w. builtin shims for leveling for Dewalt 7485/7492 and simila table saws.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple holder for the feet of a dewalt tablesaw. There is 4 files with builtin shims for 0-3mm to level the saw.
- Ocena
- 0 / 5
- Polubienia
- 46
- Pobrania
- 190
- Wydruki
- 2
- Wyświetlenia
- 1955
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I recently built a worktable with a space for my dewalt 7485 tablesaw in one end. As the table is on wheels, the saw sometimes get a little out of allignment when moving the table around.
Also, the wood got slightly out of allignment after a while, and so the platform was 2mm lower in one side than the other.
These holders fix two minor issues:
1. Holding the saw in place when moving the table and saw around.
2. Including a shim to keep the saw level. There are four models providing 0-3mm in height.
I suggest you use PETG and a fill in your models that is resistive to vertical pressure.
The holders are each mounted with 6 standard undercut screws with headsize max 7mm and threading of max 3.5mm.
Note1: If you take a closer look of the models, you will find the inner hole is of slightly different timensions. This is to compensate for the curved nature of the dewalt foot.
Note2: As the dewalt foot is made of a slightly soft material, the dimensions seem to be a litte different from foot to foot, hence the same foot-holder may be a little tight on one foot and a little loose on another.