1 / 8
Sony WH-1000XM5 Headphones Broken Slider Fix
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this when the slider of my WH-1000XM5 Headphones broke and it clamps onto the bearing and slider.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 507
- Wydruki
- 2
- Wyświetlenia
- 3709
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 13)Remiksy (0)Kolekcje (19)Powiązane
You will need a screw where the thread is M3 and 8mm long and an M3 nuts. You will need to push the wires through the gap in the print and the make sure the thicker part (bottom) is clamping onto the bearing and the slimmer part is clamping onto the slider. Then you will need to align the earcups and finally. put the screw in and the nuts on the outer side and tighten with a screwdriver and you are set.
Print without supports.