Multitool Belt Holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ozark Trail multitool replacement belt holster.
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 120
- Wydruki
- 1
- Wyświetlenia
- 803
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello! Years ago I purchased an Ozark Trail multitool at Wal-Mart; while the multitool has served me well, and continues to serve me well, the fabric holster has not. The fabric belt loop ripped out of the back and I don't quite know how to repair it as there is a layer of plastic in between some fabric. So, I designed a hard plastic holster.
My requirements were as follows:
- Fits on my belt, 35.5 mm high, 5 mm thick;
- Can retain the tool when upside down and in motion;
- Allows me to retrieve and replace the tool with one hand.
This is what I designed! Prints vertical with supports BLOCKED on the inside, and regular supports in the belt loop. I'm sure tree supports would work fine. I printed this in PETG with four walls and 35% infill.
I did shake it upside down and while the tool rattles a bit it doesn't fall out but remains easy to remove with one hand.