Multitool Belt Holster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ozark Trail multitool replacement belt holster.
- Rating
- 5 / 5
- Likes
- 32
- Downloads
- 120
- Makes
- 1
- Views
- 803
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello! Years ago I purchased an Ozark Trail multitool at Wal-Mart; while the multitool has served me well, and continues to serve me well, the fabric holster has not. The fabric belt loop ripped out of the back and I don't quite know how to repair it as there is a layer of plastic in between some fabric. So, I designed a hard plastic holster.
My requirements were as follows:
- Fits on my belt, 35.5 mm high, 5 mm thick;
- Can retain the tool when upside down and in motion;
- Allows me to retrieve and replace the tool with one hand.
This is what I designed! Prints vertical with supports BLOCKED on the inside, and regular supports in the belt loop. I'm sure tree supports would work fine. I printed this in PETG with four walls and 35% infill.
I did shake it upside down and while the tool rattles a bit it doesn't fall out but remains easy to remove with one hand.